Resources

Technical notes by process

Start with the application note that matches the process problem. Each note ends with one low-friction inquiry action.

Technical notes

Application notes before the catalogue

These pages are written as process notes. They state fit, exclusions, and the data needed for a selection review. Downloadable one-page notes will be added when a verified version exists; the first release uses the web page as the note.

Agrochemical Emulsifiers

Agrochemical Emulsifiers and Formulation Auxiliaries

An agrochemical emulsifier is not a single additive. It is a system matched to the active ingredient, solvent, water hardness, and storage condition. The useful inquiry states the formulation layer and the failure mode, not only a product name.

Read the technical page

Coatings Additives

Coatings Wetting Agents and Defoamers

A coating defect that appears as a crater, pinhole, or trapped foam is usually an interface problem, not a missing additive. The resin, substrate, surfactant load, application method, and film thickness decide whether a wetting agent or defoamer will help.

Read the technical page

Detergent Surfactants

Detergent Surfactants and Cleaning Auxiliaries

Detergency is a balance of wetting, emulsification, soil removal, foam control, and electrolyte tolerance. The same surfactant series can behave differently across temperature, water hardness, and builder system. Selection has to start from the wash condition.

Read the technical page

PCE Macromonomers

PCE Macromonomers for Polycarboxylate Water Reducers

Polycarboxylate ether performance depends on the polyether macromonomer: its molecular weight, distribution, and reactive end group. Two nominally similar macromonomers can produce different slump retention, adsorption, and batch consistency in the final water reducer.

Read the technical page

Textile Auxiliaries

Textile Wetting, Leveling, and Pretreatment Auxiliaries

A textile auxiliary is selected by what it has to do in the bath: wet out a package, penetrate a dense fabric, level a dye, resist alkali, or reduce foam. The ionic type, cloud point, and restricted-substance status follow from that process step.

Read the technical page

Anodizing & Plating

Chemical Pumps for Anodizing and Plating Lines

In anodizing and plating lines, a mechanical seal in hot acid or plating chemistry can become a repeating maintenance item. A sealless magnetic-drive pump or a lined ISO 2858 pump changes the failure mode, the housekeeping burden, and the risk of losing expensive bath chemistry.

Read the technical page

ISO 2858

ISO 2858 Chemical Pumps for Footprint Replacement

ISO 2858 and DIN 24255 dimensions exist so a process pump can be replaced without rebuilding the line. The value is in the dimensional check: casing, suction, discharge, shaft height, baseplate, and coupling must be confirmed before a replacement is proposed.

Read the technical page

Packaged Skids

Packaged Pump Skids and Booster Sets

A packaged skid should reduce site work, not move it into a drawing package. We review the process duty, the mechanical layout, the control philosophy, and the boundary of supply before quoting a pump set or transfer package.

Read the technical page

Pickling & Wastewater

Pumps for Pickling Lines and Wastewater Treatment

Pickling lines and wastewater stations concentrate the two conditions that shorten pump life: corrosive chemistry and abrasive or crystallizing solids. The selection has to separate clear acid transfer from slurry-like wastewater and choose the right material, seal method, and installation arrangement for each.

Read the technical page