ISO 2858
Replace the pump, keep the pipework
ISO 2858 and DIN 24255 dimensions exist so a process pump can be replaced without rebuilding the line. The value is in the dimensional check: casing, suction, discharge, shaft height, baseplate, and coupling must be confirmed before a replacement is proposed.
The process problem
ISO 2858
A process pump reaches overhaul time and the original brand is slow, expensive, or no longer supported. The maintenance team wants a drop-in replacement, but a catalogue claim is not enough: flange positions, shaft height, and baseplate details decide whether the line has to be cut.
Scope
Chemical and process transfer in inorganic chemicals, water treatment, surface treatment, and general plant utilities where an ISO 2858 footprint already exists.
Product family
ISO 2858 / DIN 24255 end-suction chemical pumps in cast iron, stainless steel, and lined or plastic configurations where applicable.
Qualification
Fit conditions and honest boundaries
The inquiry is useful only when the process data is specific enough to make a selection or reject the duty.
This page fits when
- The existing pump is identified as ISO 2858 or DIN 24255 dimensional.
- A footprint drawing or measured dimensions are available for the casing, flanges, shaft, and baseplate.
- The duty point can be stated with fluid, concentration, flow, head, temperature, and material.
- The motor voltage, frequency, enclosure, and coupling arrangement are known.
We exclude
- API 610 refinery or petrochemical main-process service.
- High-pressure reverse-osmosis stages beyond the offered hydraulic range.
- Slurry, high-solids, or abrasive duties.
- A drop-in guarantee based only on a model name without dimensional verification.
Please provide
- Existing pump brand, model, and serial number if available.
- Dimensional drawing or measured flange, shaft, and baseplate data.
- Fluid, concentration, temperature, flow, head, and NPSH available.
- Wetted material and seal arrangement.
- Motor data, voltage/Hz, and site environment.
Questions
Before you send the form
Is ISO 2858 a performance standard?
No. It is primarily a dimensional standard. Performance still has to be checked against the duty point. We verify both dimensions and hydraulics.
What is the minimum information for a replacement check?
The existing model or a dimensional drawing, plus fluid, flow, head, temperature, material, and motor data. A photo of the nameplate helps.
Can you confirm interchangeability before I order?
We compare the submitted dimensions and return a marked-up check. If any dimension is uncertain, we ask for a measurement rather than assuming it.
Next step
Request a replacement quotation
Provide the duty point, material, quantity basis, and drawing reference. We will confirm the technical fit before discussing commercial terms.
- One low-friction next step: sample, drawing, selection, or quote.
- Engineering questions come before price or delivery discussion.
- No public file upload. Drawings and SDS files move by email after first contact.
Your details are used only to answer this inquiry. Read the Privacy notice.